The Cost of a Trip Between Brookhaven and Sandy Springs: Navigating Gas Prices

If you're looking to travel between Brookhaven and Sandy Springs, Georgia, there are a few different routes you might take. Which one you choose will depend on a variety of factors, including your destination within Sandy Springs, traffic conditions, and, of course, gas prices. In this article, we'll take a look at the different possible routes and highlight the cost and distance of each one, ultimately recommending the best route for your trip.

Route 1: Taking GA-400

One of the most direct ways to get from Brookhaven to Sandy Springs is to take GA-400 North. This route entails jumping on I-85 N from Brookhaven, then merging onto GA-400 N via Exit 87. Depending on where in Sandy Springs you're headed, you may take one of a few exits (Glenridge Connector, Abernathy Road, or Northridge Road) to reach your destination.

The total distance for this route is roughly 11 miles and should be completed in about 20 minutes, but of course that depends on traffic. This is also the most expensive route at the time of this writing, as gas prices in Georgia are hovering around $2.50 per gallon. For a car that gets 25 miles per gallon on the highway, a one-way trip on this route will cost you about $2.75 in gas. A round trip will double that cost to $5.50.

Route 2: Taking Peachtree Road

Another possible route to Sandy Springs from Brookhaven is to take Peachtree Road. This route requires you to head north on Peachtree Road from Brookhaven, eventually crossing over I-285 and continuing north past Dunwoody and into Sandy Springs. Depending on your final destination, you may need to take a slight detour from Peachtree to get to where you're going.

This route is about 8.5 miles and should take around 20-25 minutes, depending on traffic. The cost for this route is slightly cheaper than Route 1, as you'll be driving a shorter distance. Based on the same gas prices and fuel efficiency referenced earlier, a one-way trip on this route should cost you about $2.20 in gas, and a round trip will cost $4.40.

Route 3: Taking Back Roads

If you're looking to avoid the highway altogether, it's also possible to get from Brookhaven to Sandy Springs by taking a series of back roads. This is a good option if you're looking to save money on gas, as you'll be driving a shorter distance than Routes 1 and 2. However, it may not be the fastest option depending on which roads you take and how much traffic there is.

One potential route to Sandy Springs from Brookhaven might involve taking Ashford Dunwoody Road north to Peeler Road, and then taking Peeler Road east to North Peachtree Road. From there, you can head north on North Peachtree Road into Sandy Springs. Another option might be to take Johnson Ferry Road or Roswell Road, which both run north into Sandy Springs.

The total distance for this route will depend on which back roads you take, but it will be somewhere between 7 and 10 miles. Based on the same gas prices and fuel efficiency, a one-way trip on this route should cost you around $1.75 in gas, and a round trip will cost around $3.50.

Recommendation: Taking Peachtree Road

Based on the distances, travel times, and gas prices outlined above, we recommend taking Peachtree Road from Brookhaven to Sandy Springs. While it's not the absolute cheapest route, it strikes a good balance between cost and convenience. It's also less expensive than Route 1, which involves taking the more expensive GA-400.

Conclusion

In conclusion, the cost of a trip between Brookhaven and Sandy Springs will depend on various factors such as the route you choose, traffic conditions, and gas prices. While there are several possible routes you could take, we recommend taking Peachtree Road as it is comparatively cost-effective while still being a reasonably quick journey. Whether you're headed to Sandy Springs for work, leisure, or anything in between, we hope this guide helps you navigate your trip confidently and cost-effectively.