The Cost of a Trip Between Buffalo, New York and Hyattsville, Maryland

Traveling between Buffalo, New York, and Hyattsville, Maryland, can be a long journey covering almost 400 miles. Before planning such a trip, it is crucial to take into account the cost of the journey, especially when it comes to transportation. In this article, we will discuss the cost of different possible routes and recommend the most cost-effective option.

The Different Possible Routes

There are mainly two routes that one can take in traveling between Buffalo, New York, and Hyattsville, Maryland. One is the direct route, which follows interstate 90 and takes about 6 hours and 30 minutes to cover the 380-mile distance. The other route is through Pittsburgh, Pennsylvania, which involves taking the I-90 to the I-79 and then the I-76 Turnpike and the I-70 to reach Hyattsville, Maryland. This route covers 455 miles, and the estimated time of travel is roughly 8 hours 30 minutes.

The Cost of the Direct Route

When it comes to transportation, the most common method of traveling between Buffalo and Hyattsville is by road. The direct route, which is approximately 380 miles, can be covered by car or a bus. If one chooses to drive by car, the approximate fuel cost would be around $53-60, depending on the consumption rate of the vehicle. However, it is important to note that the fuel costs vary depending on the current gas prices. Additional costs include toll fares, which vary from state to state. The estimated toll fares for the New York State Thruway are $10.00, the Pennsylvania Turnpike is $45.80, and the Maryland toll roads vary by location, with varying fees of $4.00 to $24.00. If one chooses to take a bus, prices can range from $60 to $100 depending on the day and time of the trip.

The Cost of the Route through Pittsburgh

Alternatively, one can opt to take the route through Pittsburgh, Pennsylvania. The approximate fuel cost by car would be $70-80, depending on the consumption rate of the vehicle. The estimated toll fares would also vary on this route. The estimated toll cost on the Pennsylvania Turnpike is $45.80, with additional toll fees in Pennsylvania that can vary depending on the distance. These toll fees can range from $3.30 to $9.90. In Maryland, toll fees will be in the range of $4.00 to $24.00, depending on the location. Again, if one chooses to take a bus, prices can range from $75 to $120, depending on the day and time of travel.

Recommendation

In terms of cost-effectiveness, a direct route is usually the best option when traveling between Buffalo and Hyattsville. Not only does it save time with the travel distance being shorter, but it is also cheaper, with the cost of driving ranging from $53-60, with around $10-15 being the total toll fees. If one is short on time, a direct flight could be an alternative approach, with current prices ranging from $300 to $500, depending on the airline and time of travel.

Conclusion

In conclusion, there are two main routes to travel between Buffalo, New York, and Hyattsville, Maryland, with the direct route being the most cost-effective option. However, it is important to consider other factors such as the time of travel and the frequency of toll fees when making a decision on which route to take. With proper planning and budgeting, a smooth and comfortable trip can be enjoyed from start to finish. The travel time depends entirely on the method of travel, but a safe estimate is around 6 hours and 30 minutes.